AluminumAlloyBoats.com

IN2DEEP
sorry I am a welder not a writer
If I do not explain my self well ask
or call my shop from my link
I might be able to say something better than type it

RIB

current running thru the bearings can be very bad along with other stuff I have destroyed like hinges, bolts or just about any thing you need to move metal on metal fold down towers when I leave the ground on the bottom 1\2 and weld up top ark mark then gaul seize oops a few hundred $$$ mistake Pre ...

I left the oil in and change it after I'm done.

The weld area gets pretty hot but
the heat dissipates fast enough not to cook the oil

A little work for my self this morning http://i293.photobucket.com/albums/mm67/gandrfab/DSC00044.jpg http://i293.photobucket.com/albums/mm67/gandrfab/DSC00045.jpg http://i293.photobucket.com/albums/mm67/gandrfab/DSC00046.jpg Man I hate grinding but gota do it http://i293.photobucket.com/albums/mm67/...

Has any one worked with this Co. before?

http://tunadawg.com/_wsn/page4.html

I have been using a 1\8" SS wire bent into a hook for dehooking
fixed to a wood handle

for venting I have used a marinade injector with the back cut off

Every one does stuff different if for teasers I would run the line to the first eye when the big one is on pull the bars right to the eye let them hang up in the air out of the way and I would run a single line to the tip for fishing I think pulling that much from the end would make for a short rigg...

Well I'll be trolling 4' Spreader Bars with 15-13" squid.
light weight surface kind or heavy like a dredge?

Do you run your arms straight out or do you run them slightly pointing aft or towards the stern? I lock them strait out with the pull from the lures and or bait thay tend to go aft some Do you single rig or double rig them? I like the single rig my self but fishing with them double is not to hard

The one thing that bothers me is that the poles aren't pinned into the elbows. I may add a pull pin as a safety precaution........... with the out rigger lines clipped to the boat the poles can't come out It has worked well for me to find a spot where the outrigger line are snug in the out position ...

Never used these so I'm assuming the "finger" clamp on ring is what stops the elbows/pole from drifting from my spreader bar tension...... yes and this is hard for me to explain on a keyboard the handle is also suppost to work like a cam lock http://i293.photobucket.com/albums/mm67/gandrfa...

nice good set
Thing to keep an eye on is the metal on metal
It can gaull and lock up
after salt water use good rinse
every few trips out open the clamp handle and lube

How thick is your hard top?



link to rupp's site

http://www.alltackle.com/rupp_standard_top_guns.htm

what pair do you have?

The original top gun

with standard elbows or radial

or the Z-30?

or one of the other riggers

Nice find

going to have to get one or two

I would like to build a aluminum boat

but I am not a engineer or hull designer

who would I goto fore a CNC cut and shipped boat?

21' + bay boat

1\2 tower with fold down look out



[/img]

Do you do the glass work too? no
I order the E-box with my pipe orders
from Eastern metal supply


(edit) I do enjoy drilling holes in fiber glass

see if I got this right

I do almost all custom work

I have had a few years working for aluminum air boat builders

Hello all,great site

I have been building T-tops and Towers for about 10 yrs

and would like to build about a 25' to 28' center console