outboard height

Motor discussion
capewelder
Posts: 2
Joined: Thu Mar 31, 2016 12:05 pm

outboard height

#1

Post by capewelder » Thu Mar 31, 2016 12:28 pm

Ok guys im doing a full refit on a 26' landing craft at the monment. this boat has been messed with A LOT over the years. She originally started life as a 350 Merc/ Hamilton jet set up, and for some reason it was pulled and transom and porch cut out and notched for a o/b. had a 225 hp oceanrunner i have no performance info for the old motor but now shes getting treated to a Honda 225. The hull has a delta pad has the remnants of the jet intake still there, which i found today was only covered with .125 sheet that was held in place with self tapping screws and 5200!! So that brings me to the big question for hopefully some one here is more familiar with delta pad hulls than I am. We will be raising the transom for the Honda which is a 30" leg and i am not overly sure where to set the height, i would assume it would be a little below the pad. the boat is going to be used as a work/ tow boat for the most part so not super worried about top speed on this build.

ill try and take some pictures of this thing later on.

Chaps
Donator '09
Posts: 2096
Joined: Sun Jan 13, 2008 12:19 am
Location: Seattle, WA

Re: outboard height

#2

Post by Chaps » Thu Mar 31, 2016 7:31 pm

go deeper on a work boat, you want to bite clean water and top speed is not your issue. My Suzuki is on a Porta bracket so I can run it up and down at will and for best towing power and maneuverability I lower it way down
1987 24' LaConner pilothouse workboat, 225 Suzuki
Image
please view and like: https://www.facebook.com/bottompainting/

Post Reply Previous topicNext topic