The Welderbob "special?"

[JETTYWOLF]

Did I read (Big W & I were talkin') that WelderBob would build this boat for ya starting at 50K, with a 150HP?

Bob, did ya say that?


Elaborate??

Cause if I was just a "Joe" out fishing for myself for fun. This 20 footer would get a serious look from me. And I'm not a cabin guy. But then again this is just a Wolfie haus. Not really a floating winnabego. Not big enough to be. C'C'mon.....

Damn I wish we could see the inside

[welderbob]

Yes I think I did. I am a little crazy. I'll pay Bill Lincoln to create the cutting file. I'll build the boat and install a 150 hp Honda. If you want something else it might be a little more. I'll paint the bottom and put an 8 breaker blue sea panel in the overhead box. The government says I have to put running light on it and an EPA fuel system.
.250 5086 bottom
.190 5086 sides
.190 beck
.125 and .190 5052 cabin/console.

I through it out there once and no one nibbled. I'll even put it on a trailer for $100.00 dollars over my cost. You want a $500 watertight hatch in the deck, you pay for the hatch I'll put it in.

The shop is very busy this month with all of the "spring stuff". The mad rush will be over soon.
Simple terms.
A simple hand shake makes the deal.
$20,000. when the cut aluminum lands on my shop floor
$10,000 when the boat is acid wash/ finished fabrication.
Balance upon delivery
I may regret hitting the send button,here we go.

Welderbob

[JETTYWOLF]

Hey,

If I was back in the market I'd really be into a nice small boat like that.

Welder and I were talking about prices these days and I told him you mentioned that. I was and wasn't "CHEERLEADING"...

Just that there soooooo many people who come here looking for a DEAL on a new boat, and that would be one.

I've come to the realization. If you fish the same area all the time. You really don't need $50K of electronics. I fished for two years one time with a single 2" round depth gauge on a dealer demo boat and was fine.

Can you come here and put a nice big aluminum deck hatch in my boat for me. I like the ones that remind me of a submarine hatch.

A few coolers, some rod holders and that would be a Great Lakes boat from hell....making the Lund dudes very envious.

Just wish I could see the inside, too.

[welderbob]

Wait till you see next months special.

Welderbob

[Sabs28]

Wait till you see next months special.

Welderbob

Do you mean we will see it tomorrow????

[welderbob]

http://aluminumalloyboats.com/viewtopic ... kway+skiff

It could look something like this. Material is cut and on the floor of the shop. Will start new thread.

welderbob