Page 1 of 1
vexilar "alumaducer"
Posted: Mon Mar 02, 2009 12:00 pm
by cgrand
maybe this is still a pipe dream, but has anyone had any success using this in a 1/4" bottom plate?
i broke off my transom mount the other day, and before i get another one, i am looking at options.
hope everyone here is well!
CG
Re: vexilar "alumaducer"
Posted: Mon Mar 02, 2009 12:44 pm
by welder
Chris, you are still kicking
Give this question a day or two and I bet we have a answer.
I will be through your way again in June and would like to buddy boat out or same as last time. I wanted to spend a couple 2 or 3 days in fourshon this time and I'll be in Pensacola for about 2 1/2/ weeks.
Re: vexilar "alumaducer"
Posted: Mon Mar 02, 2009 9:10 pm
by keith
Their web site says it only works up to .150 thickness.
Re: vexilar "alumaducer"
Posted: Wed Mar 04, 2009 8:18 am
by JETTYWOLF
welder wrote:Chris, you are still kicking
Give this question a day or two and I bet we have a answer.
I will be through your way again in June and would like to buddy boat out or same as last time. I wanted to spend a couple 2 or 3 days in fourshon this time and I'll be in Pensacola for about 2 1/2/ weeks.
CHALLENGE......
GO CATCH A BOX O' TROUT IN FOUCHON!
ACCEPTED?