Dave,
Thanks for your time on the phone. I see that I need to lower those protective chines about 6" for floating docks. Also, went to the kobelt website....need the helm pump and steering cylinder...epoxy coated on the cylinder...what about the pump casing....same?
When ordering...I'll see if Jay can make these changes...should only cost a few hundred more to upgrade.
thanks
kobelt systems
-
- Posts: 19
- Joined: Fri Jun 06, 2008 9:21 pm
- 16
- Location: Richmond Virginia
- JETTYWOLF
- Contributor/donator/Location Nazi
- Posts: 6074
- Joined: Sun Jan 06, 2008 9:11 pm
- 16
- Your location: JACKSONVILLE FL USA
- Location: Tree-hugger, USA...they call it FLA.
You don't need the stern cylinder epoxy coated, and maybe not even the helm pump, but if you were, the helm pump is all that you'd want or need epoxy coated.
I put pics up in your other question about trailers of my rolls axle.
I talked to Jay today, and said I sent Kobelt checkers to him.
He's familiar.
Good luck and keep us updated.
I put pics up in your other question about trailers of my rolls axle.
I talked to Jay today, and said I sent Kobelt checkers to him.
He's familiar.
Good luck and keep us updated.
-
- Posts: 19
- Joined: Fri Jun 06, 2008 9:21 pm
- 16
- Location: Richmond Virginia
thanks
Thanks again Dave,
If I can make it down that way, we will have to go Gator huntin' .... trout that is!
If I can make it down that way, we will have to go Gator huntin' .... trout that is!