Page 1 of 1
Custom Series Aussie Alloy
Posted: Wed Dec 14, 2011 4:17 am
by NTGeorge
Hey Guys
Things are a little quiet at the moment so I have the chance to catch up on some computer stuff. thought you would like to see some pic's of the last boat to roll out the door.
It has all be water tested since these photos, and is being used and abused on a regularly basis.
Re: Custom Series Aussie Alloy
Posted: Fri Dec 16, 2011 8:10 am
by dawgaholic
From the looks of her, you be the one delivering the pain! Ruggedly constructed and I'm really digging the stern set-up and tuna door.
If you are already fishing her, show us the finished beauty!
Re: Custom Series Aussie Alloy
Posted: Fri Dec 16, 2011 4:56 pm
by NTGeorge
Howd'y
I have to catch up with the owner and try and get some water shots, I went out for the water test but all the pic's that were taken were mostly from within the boat.
At the moment this is all I have
Re: Custom Series Aussie Alloy
Posted: Tue Jan 31, 2012 12:02 am
by CTMD
My first time on here for a while boat looks great. Is it one of Adam's or a Plate Alloy Australia boat? Looks a lot like PAA's 5.3m.
Re: Custom Series Aussie Alloy
Posted: Wed Feb 01, 2012 4:48 am
by NTGeorge
Hey Chris
Na actually it's neither, it's a CNC marine by Steve Chappel. I got a really really good rate offered by onesteel perth for materials and cutting, ended up cheaper to get it down there and shipped up than it was to get cut in melbourne or localy in Darwin even.
Your builder in townsville seems to be punching out some nice hulls.
Cheers